Dogwidgets DW-4 사용자 설명서
{카테고리_이름} Dogwidgets DW-4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dogwidgets DW-4 2 페이지. 2 dog training vibration collars
페이지 인쇄
Dogwidgets DW-4 2 dog training vibration collars user's manual
Preparation:
1) Check the 9-volt battery of the remote control and see if it's properly installed because the factory installed it
upside down to save the battery life. The +/- side of the battery should touch against the 2 springs of the remote
control. Follow the diagram inside the battery compartment on where to put the +/- side of the 9-volt battery.
2) Charge the collars for 8 hours straight for the first charge and 4 to 6 hours after. The red led light of the collar
will flash, meaning the collars are charging. Red led light of the collars will go solid after a full charge.
3) Install the strap to the collar by inserting them through the 2 brackets on the collar. Adjust the length and snug
fit the collar to your dog's neck.
Training tips:
1) Familiarize the collars and the remote control and check the collars if they are working properly and safely
before putting them on your dogs.
2) Always praise your dog after a punishment.
3) #1 button is 1 vibration, #2 button is 2 vibration and #3 button is 3 vibrations.
Troubleshooting the collars:
1) The collar has a built-in motion sensor. The collar will go into sleep mode after few minutes if it doesn't sense
any movement from the dog or if it's not in use to save the battery life. Shaking the collar will turn the collar back
on.
2) The collar has a built-in Lithium-Ion battery that can be charge by the wall charger or on the USB port of the
computer. If the collar won't hold a charge by the wall charger, try charging the collar on the USB port of the
computer, if the collar charges on the USB port then the wall charger needs to be replaced.
3) If the collar has power but won't respond to the remote control or would only work half the time, then the collar
needs to reset.