Doheny's ProJet Free Plus-650 사용 설명서 - 페이지 4

{카테고리_이름} Doheny's ProJet Free Plus-650에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Doheny's ProJet Free Plus-650 10 페이지. Battery- operated robotic pool cleaner for aboveground pools

페이지 인쇄

Assembly

A: Floater

B: Upper cover

B-1: Jet head

C: Cartridge filter

D: Filter

E: Bottom base

F: Charger

G: Hook

The jet head (B1) rotates 180 degrees as the water flows through the

bottom base (E), the filters (C & D) and the upper cover (B). The

water flow passing through the jet head propels the robot across the

pool floor. Should an obstacle prevent the robot from moving

forward, the jet head turns 180 degrees and sends the robot in the

opposite direction. The debris is collected and stored in the bottom

base (E) of the cleaner as clean water passes through the filter (C)

Assembly and operation

Charging the cleaner

Use only the original external adapter and

Make sure the robot and charger ports are clean and dry before installation.

Charge the robot before using it for the first time (about 5 hours).

Remove the pin cover from the charging port located under

the cleaner. To avoid losing the cover, attach the pin cover to

the charging cable.

Place the charger plug into the charging port at the

bottom of the cleaner, then plug the charger into

the power supply to begin charging the cleaner.

Note: Once the robot starts charging, the

indicator light on the external adapter will turn red.

When the robot is fully charged, the indicator light will

turn green.

When fully charged, pull the charger plug

out of the charging port at the bottom of the

cleaner. Securely place the pin cover over

the charging port making sure the port is

sealed before placing the cleaner in the

water.

charging cable provided.

B-1

Bottom cover body assembly bottom

Pin cover

Charging port

Switch

Charger