Cynergy3 IWTxT-000 운영 매뉴얼

{카테고리_이름} Cynergy3 IWTxT-000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cynergy3 IWTxT-000 11 페이지. Wireless transmitter with tx supply adds wireless functionality to any 4-20 ma transmitter

페이지 인쇄

| IWTxT SERIES

WIRELESS 4-20mA TRANSMITTER OPERATING MANUAL

WIRELESS TRANSMITTER WITH TX SUPPLY

ADDS WIRELESS FUNCTIONALITY TO ANY 4-20 mA TRANSMITTER

Whilst every effort has been taken to ensure the accuracy of this document, we accept no responsibility

for damage, injury, loss, or expense resulting from errors or omissions, and reserve the right of

amendment without notice.

Information for users

This equipment has been tested and found to comply with the limits for a Class B device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses and can radiate radio frequency

energy, and if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

•

Connect the equipment into an outlet on a circuit different from that which the receiver is

connected

Consult the dealer or an experienced radio/TV technician for help

•

Caution: To satisfy FCC RF Exposure requirements for mobile and base station transmission

devices, a separation distance of 20cm or more should be maintained between the antenna of this

device and persons during operation. To ensure compliance operation at closer than this distance

is not recommended. The antenna used for this transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter. No other antenna may be used with this

equipment other than the PCB antenna supplied with this equipment.

This document may not be reproduced in any way without the prior written permission of the company.

IWTxT Series

Cynergy3 Components Ltd

7 Cobham Road, Ferndown Industrial Estate, Wimborne

Dorset BH21 7PE, United Kingdom

Tel: +44(0)1202 897969, email: [email protected]

www.cynergy3.com

Page 1