1010music Bitbox Micro 2.2 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} 1010music Bitbox Micro 2.2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 1010music Bitbox Micro 2.2 4 페이지.

CLEAR A PAD

1. Select a loaded pad and push the Right Arrow button to display the Waveform screen.

2. Touch the Pad Mode icon to the left of the WAV file name at the top of the screen and

then touch New Rec. You will now see the Load and Record screen.

INPUTS AND OUTPUTS

The bitbox micro has 8 input and 8 output ports. By default, all inputs are set to Gate mode.

Outputs 7 and 8 are configured as the main audio outputs, playing audio routed to buses

Out1 and Out 2 with FX applied. Push Tools to access the Inputs and Outputs screens, then

turn the bottom knob to change the setting for the selected port.

Connection Port

Inputs 1 – 2:

Inputs 3 – 8: Gate, CV, Clock

Outputs 1-8:

A gate signal on a Gate input will trigger the corresponding pad. Connect a controller to the

MIDI In port to trigger pads and modulate parameters.

RECORD A WAV FILE

1. Configure the Inputs to Receive Audio:

Push Tools twice to go to the Input screen. The input grid maps to

▪

the array of input ports below the screen.

Turn the bottom knob with input 1 selected to choose Audio.

▪

Repeat for input 2.

Plug the recording source into Inputs 1 and 2.

▪

2. Push Home. Select an empty pad and press the Right Arrow button

to display the Load and Record screen.

3. Use the knobs to select parameters and assign values.

4. Touch the Rec button. The bitbox micro will start recording. The

timing of the recording can be synchronized with the clock by using

the Rec Quant parameter. Recording will start when a signal is

received if you set the Threshold parameter to On.

5. Touch the Stop button to end recording. If you configured a recording

length, bitbox micro will stop recording when the target length is

reached. The file will be saved in a folder with the same name as the

preset under the \Presets folder on the microSD card.

Configuration Options

Gate, CV, Clock, Audio

Assignable to Audio Buses Out1 - Out8, Out 1+FX and

Out 2+FX.

Input

Load and Record

Page 3