ASG DTT-30 운영 매뉴얼 - 페이지 6

{카테고리_이름} ASG DTT-30에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASG DTT-30 12 페이지.

The LCD display will show the torque that the driver or wrench is set at. Note the

reading or write It down. To enter it into the DTT memory press the "MEM / ENTER"

button. If you are testing several tools note the memory numbers of the readings for

the various tools. This number is in the bottom right hand corner of the LCD. The unit

can save up to 200 readings. After that no further readings can be entered until the

memory is cleared. See the operating manual for instructions on downloading and

clearing the readings in the memory.

If the torque is not correct, adjust the tool. Repeat the test. When the reading is

proper perform the test several times to be sure the readings are stable. The proper

reading may be an average of several readings.

PROCEDURE FOR POWER SCREWDRIVERS

Put the driver adapter into the unit's female 3/8" square socket. This is also called a

joint simulator. It allows the power tool to reach its working speed before tightening

up and causing the clutch to operate

Run the tool in reverse to make sure the adapter is unwound. Take care not to

disassemble the driver adapter.

Make sure the unit is in PEAK mode. If it is not use the "MODE" button to select Peak

mode. Press the "RESET / ESC" button to be sure the display is at 0Run the tool

forward until it shuts off. The reading on the display will be the torque setting of the

tool's clutch. Note the reading or write it down. To enter it into the units memory

press the "MEM / ENTER" button. If you are testing several tools note the memory

numbers of the readings for the various tools. This number is in the bottom right hand

corner of the LCD. The unit can save up to 200 readings. After that no further readings

can be entered until the memory is cleared. See the operating manual for instructions

on downloading and clearing the readings in the memory.

If the torque is not correct, adjust the clutch. Repeat the test. When the reading is

proper perform the test several times to be sure the readings are stable. The proper

reading may be an average of several readings. ALLWAYS UNWIND THE DRIVER

ADAPTOR AFTER EACH TEST. DO NOT LEAVE THE SPRING UNDER TENSION

WHILE NOT IN USE

Use an adapter that has a higher capacity than the tool you are using. Before using

the adapter, make sure the thread is unwound but engaged. Turn the shaft by hand to

make sure the thread is turning smoothly and the bearing is also turning smoothly.

Refer to the pictures below to identify the various driver adapters and springs to

determine the proper set up to obtain the correct match for measuring torque