CYP COH-Rx 운영 매뉴얼 - 페이지 7

{카테고리_이름} CYP COH-Rx에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP COH-Rx 16 페이지. Hdmi to optical transmitter and receiver
CYP COH-Rx에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지)

페이지 인쇄

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter Front and Rear Panels

HDMI

INPUT

ERROR

HDMI LINK

This blue LED will illuminate when at least one optical cable is

connected and has successfully detected and sent, between the

Transmitter and Reciever, a signal containing video or audio data.

ERROR

This red LED will illuminate when there appears to be an error in the

input signal data rate that is higher than 75MHz or the HDMI output

signal is not compatible.

HDMI INPUT

Connect to an HDMI input source such as a DVD or Blu-ray player

with a HDMI cable.

OPTICAL LINK

This blue LED will illuminate when the optical cable is connected

and has successfully detected and communicated data between

the Transmitter and Receiver.

Note: If the LED is not illuminated then users will need to check

the connection of the fiber cable between the Transmitter and

Receiver units and then check the connection is good and that

the cable itself is correct and undamaged.

OPTICAL

Connect the Transmitter and Reciever units with fiber optical cable

to transmit the data signal.

Note: Connector Type: LC-LC, Fiber: Duplex Multi-mode Fiber

DC 5V

Plug the 5V DC power supply into the unit and connect the

adaptor to an AC outlet. The LED will switch on when the power

cable is plugged in.

OPTICAL

LINK

DC 5V

OPTICAL