CYP CPLUS-V2PE 운영 매뉴얼 - 페이지 7

{카테고리_이름} CYP CPLUS-V2PE에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP CPLUS-V2PE 20 페이지. 1 by 2 uhd scaler with audio de-embedded

6. OPERATION CONTROLS AND FUNCTIONS

POWER

4K2K

POWER LED: This LED will illuminate when the device is connected

with power supply.

4K2K LED: This LED will illuminate when the input source contains

4K2K signal.

SYNC LED: This LED will illuminate when the input source is sending

signal.

MENU: Press this button to enter into OSD menu and when under

OSD selection press this button to exit. Press and hold this button

together with TEST PATTERN "-" button for 3 seconds to set the

device back to factory default.

TEST PATTERN -/+: Press these buttons to select patterns to display

on outputs instantly. Press these buttons together to switch output

timing to 1280x720@60 instantly. When under OSD selection, press

these buttons to roll the scroll.

ENTER: Press this button to enter and confirm OSD selection.

Press and hold this button together with the MENU button for

3 seconds to enter into firmware update mode. The LEDs will

illuminate in circle from left to right. Plug in the USB thumb drive

with updated firmware inside and the LEDs will stop illuminating.

Once the update procedure completed or successfully, all LEDs

will illuminate together but if update failed no LED will illuminate.

The device will automatically reboot after 10 seconds or user may

re-power on the device manually.

SYNC

TEST

PATTERN

–

ENTER