Ash Liberty Solo 사용자 설명서 - 페이지 11

{카테고리_이름} Ash Liberty Solo에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ash Liberty Solo 15 페이지.

Function descriptions

Swap cameras. This function will change the display to alternate

between the two cameras (if connected). There will be a brief blank

while the image is swapped. If a second video source is not detected,

the unit will beep and swap back to the original camera. The second

video source can be either PAL or NTSC format, and can be taken from

any suitable source, e.g. camcorder, video/DVD player, etc.

You can choose this function to be assigned to both-mouse-buttons for

ease of swapping while reading.

Line marker/Blinds. This function will display an underline or

dimming blinds over the image. It functions in both reading modes but

not in full color mode.

To change the gap between the blinds, hold the function button in for

three seconds until the sound is heard and use the scroll knob to adjust.

Press any button to exit the adjustment mode.

Color select. This function will change the "ink" and "paper" colors

on the display. There are a number of pre-defined color combinations

that can be cycled through by pressing the function key.

If you want a color combination that is not built-in, then press and hold

the function key for three seconds until the sound is heard. Use the

scroll knob to adjust the paper and ink colors and press any key when

the displayed colors are correct.

Digital magnification. Press the function button to turn digital

magnification on or off. It always returns to the last level of

magnification used.

To adjust the level of digital magnification, press and hold the function

button and a scale will appear at the bottom of the display. Use the

scroll knob to adjust to the desired level and press any key to accept.

Page 11

Rev E EN