CYP CSC-6015 운영 매뉴얼 - 페이지 8

{카테고리_이름} CYP CSC-6015에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP CSC-6015 20 페이지. 4k uhd+ hdmi to hdmi scaler quad-set

6. OPERATION CONTROLS AND FUNCTIONS

LOCK

POWER

–

ENTER

Note: The functionality of scaling units A, B, C, and D is identical,

however each unit is controlled, and operates, independently.

POWER LED: This LED will illuminate when the unit is receiving power.

When a valid HDMI source is detected the LED will be green, if

there is no valid HDMI source, the LED will be red.

MENU: Press to enter the OSD menu, or to back out from menu

items.

Note: Press and hold the "MENU" button for 3 seconds while

connecting the power supply to reset all settings to the factory

defaults. Pressing "MENU" and "−" together will reset the output

resolution to 720p@60Hz. Pressing "MENU" and "+" together will

reset the output resolution to XGA (1024×768@60Hz).

− & +: Press to move up and down or adjust selections within OSD

menus.

ENTER: Press to confirm a selection within the OSD or to go deeper

into a menu item.

LOCK: Pressing and holding the "ENTER" and "+" buttons for 3

seconds activates the front panel Lock Mode. The power LED

will blink red multiple times to indicate that Lock Mode has been

activated. To deactivate the front panel Lock Mode, press and

hold the "ENTER" and "+" buttons again. The power LED will

blink green multiple times to indicate that Lock Mode has been

deactivated.

Note: When Lock Mode is active the OSD menu will be disabled,

however OSD signal info will still display normally. If a button is

pressed while Lock Mode is active the power LED will blink red 3

times.

LOCK

POWER

–

LOCK

ENTER

POWER

–

LOCK

ENTER

POWER

–

ENTER