Doka Framax stripping corner I Series 원본 사용 설명서 - 페이지 5
{카테고리_이름} Doka Framax stripping corner I Series에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Doka Framax stripping corner I Series 18 페이지.
페이지 인쇄Original Operating Instructions Framax stripping corner I hydraulic
CAUTION
Danger of crushing!
➤
No body parts or objects between hydraulic
cylinder and assembly plate.
➤
Installation of the hydraulics.
➤
Putting into operation.
➤
Move the stripping cylinder into position at the hole
of the adapter.
➤
Insert Connecting pin 10cm into the stripping cylin-
der and the adapter and secure with Spring cotter
5mm.
B
K
A Spring cotter 5mm
B Connecting pin 10cm
K Fixing
Tighten or back off the hexagon nut (width-
across 41 mm) of the adapter to facilitate
insertion of the Connecting pin 10cm into the
stripping cylinder.
Spanner size (width-across): 41mm
999239002 - 07/2018
Adjustment of the Framax stripping
cylinder I
Note:
In the initial position, the stripping cylinder must be fully
retracted and holding plates A and B of the stripping
cylinder must be horizontal.
A
A Holding plate A
B Holding plate B
If holding plates A and B point up, the following steps
9239-200-02
are necessary:
A Holding plate A
B Holding plate B
1)
2)
3)
4)
5)
A
A
Remove the Connecting pin 10cm.
Back off the hexagon nut (width-across 41 mm) by
the desired difference.
Extend the stripping cylinder until the Connecting
pin 10cm can be reinstalled.
Secure each Connecting pin 10 cm with a Spring
cotter 5mm.
Fully retract the stripping cylinder.
Check that the holding plates are horizontal.
If necessary, repeat steps 1 to 5.
B
B
5