3M Air-Mate PAPR 520-03-63R01 사용자 지침 - 페이지 4

{카테고리_이름} 3M Air-Mate PAPR 520-03-63R01에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Air-Mate PAPR 520-03-63R01 17 페이지. Belt-mounted high efficiency powered air purifying respirator
3M Air-Mate PAPR 520-03-63R01에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지)

페이지 인쇄

Airflow decreases or stops

–

Any part of the system becomes damaged

–

Airflow into the respirator decreases or stops

–

Breathing becomes difficult

–

You feel dizzy or your vision is impaired

–

You taste or smell contaminants

Your face, eyes, nose or mouth become(s) irritated

You suspect that the concentration of contaminants may have reached levels at which this respirator may

no longer provide adequate protection.

Do not expose blower/filter assembly directly to sparks or molten metal spatter. Direct contact with sparks or

molten metal spatter may damage the filter, allowing unfiltered air into the breathing zone, which may result

in sickness or death, and may cause the filter or blower housing to ignite, resulting in serious injury,

sickness or death.

Do not clean respirator with solvents. Cleaning with solvents may degrade some respirator components

and reduce respirator effectiveness. Inspect all respirator components before each use to ensure proper

operating conditions. Failure to do so may result in sickness or death.

Never attempt to clean filters by knocking or blowing out accumulated material. This may result in damage

to the filter membrane allowing hazardous particles to enter the breathing zone, resulting in sickness or

death.

USE INSTRUCTIONS AND LIMITATIONS

Important

Before use, the wearer must read and understand these User Instructions. Keep these User Instructions for

reference.

Use For

Respiratory protection against certain airborne particulate contaminants including dusts, fumes, mists,

radionuclides and asbestos.

Do Not Use For

Protection from gases or vapors

Oxygen deficient atmospheres

Contaminant concentrations that are unknown or immediately dangerous to life or health (IDLH)

Contaminated concentrations that exceed the assigned protection factor (APF) recommended for the

applicable headpiece or the APF mandated by specific government standards, whichever is lower.

Refer to additional limitations and cautions under NIOSH Cautions and Limitations.

Respirator Selection and Training

Use of these respirators must be in accordance with applicable health and safety standards, respirator

selection tables contained in such publications as American National Standards Institute (ANSI) Z88.2-1992,

Canadian Standards Association (CSA) Standard Z94.4 or pursuant to the recommendations of an industrial

hygienist. The employer must have a written respirator program in place which is in accordance with the

Occupational Safety and Health Administration (OSHA) respiratory protection standard found in 29 CFR

1910.134 prior to using any respirator. In Canada, follow CSA standard Z94.4 or the requirements of the

authority having jurisdiction in your region.