CYP PU-8H8HBTE 운영 매뉴얼 - 페이지 7
{카테고리_이름} CYP PU-8H8HBTE에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP PU-8H8HBTE 20 페이지. 8x8/4x4 hdmi hdbaset matrix (5-play including lan serving)
페이지 인쇄
6.2 Rear Panel
3
6
ALL
A
IR OUT
IR OUT
CAT5e/6 OUT
IR IN
IR IN
1
2
4
5
8
1
LAN: Connect an active Ethernet port for network signal sharing
with receivers with LAN function for a data transmission rate of
100Mbps or when anyone of the receivers connected to this
device is connect with an active Ethernet port all receivers with
LAN function and this device will also access the Ethernet function.
This port is also the link for Telnet system and web GUI controls,
further details please referes to section 6.8 & 6.9.
2
RS-232: Connect to a PC or laptop with D-Sub 9-pin cable for the
transmission of RS-232 commands.
3
ALL IR OUT: Connect to the IR blaster (included in the package) for IR
signal transmission of the source or display equipment. Place the IR
blaster in direct line-of-sight of the equipment to be controlled.
4
ALL IR IN: &RQQHFW WR WKH ,5 H[WHQGHU LQFOXGHG LQ WKH SDFNDJH IRU
IR signal reception of the remote control of this device or the source
and display equipment. Ensure that remote being used is within the
GLUHFW OLQHRIVLJKW RI WKH ,5 H[WHQGHU
5
SERVICE: Manufacturer use only.
6
IR OUT 1~8: Connect the supplied IR blasters (included in the
package) for IR signal transmission. Place the IR blaster in direct line-
of-sight of the equipment to be controlled.
7
IR IN 1~8: &RQQHFW WKH VXSSOLHG ,5 H[WHQGHUV LQFOXGHG LQ WKH
package) for IR signal reception. Ensure that remote being used is
ZLWKLQ WKH GLUHFW OLQHRIVLJKW RI WKH ,5 H[WHQGHU
B
C
IR OUT
IR OUT
CAT5e/6 OUT
CAT5e/6 OUT
IR IN
IR IN
1
2
3
HDMI IN
HDMI IN
HDMI IN
D
E
IR OUT
IR OUT
IR OUT
CAT5e/6 OUT
CAT5e/6 OUT
CAT5e/6 OUT
IR IN
IR IN
IR IN
4
5
HDMI IN
HDMI IN
9
7
F
G
H
IR OUT
IR OUT
CAT5e/6 OUT
CAT5e/6 OUT
IR IN
IR IN
6
7
8
HDMI IN
HDMI IN
HDMI IN
GND
GND
2
1
4
3
V+
+
V
GND
POE 24V
MAIN 24V
10
11
4