Akron OMEGA SD 3524 설치, 운영 및 유지보수 지침 - 페이지 2

{카테고리_이름} Akron OMEGA SD 3524에 대한 설치, 운영 및 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Akron OMEGA SD 3524 2 페이지.

OPERATING INSTRUCTIONS:

The tiller bar and the upper and lower brake knobs are used to control the monitor. To change the horizontal monitor position toward

the "RIGHT" or "LEFT", get a firm grip on the tiller bar handle and turn the lower brake knob counterclockwise until the unit can be

easily rotated. Turn the same knob clockwise to lock the unit in the desired horizontal position. To change the vertical monitor posi-

tion upward or downward, get a firm grip

on the tiller bar handle and turn the upper brake knob counterclockwise until the unit can be easily elevated or lowered. Turn the

same knob clockwise to lock the unit in the desired elevation position.

CAUTIONS:

Your monitor and nozzle should be inspected prior to and after each use to ensure it is in good operating condition. Periodically, an

unanticipated incident occurs where the unit is misused in a manner that is inconsistent with standard operating practices. A partial

list of potential misuses includes:

• Operating above maximum rated pressure or flow.

• Not draining and allowing water to freeze in the unit.

• Prolonged exposure to temperatures above 140 degrees F, or below -40 degrees F.

• Operating in a corrosive environment.

• Other misuse that may be unique to your specific environment.

Also, there are many "tell tale" signs that indicate repair is in order, such as:

• A hand wheel that is inoperable or difficult to operate.

• Excessive wear.

• Poor discharge performance.

• Water leaks.

If any of the above situations are encountered, the monitor should be taken out of service, repaired and tested by a qualified techni-

cian before placing it back in service.

MAINTENANCE INSTRUCTIONS:

• Periodically lubricate the grease fittings with Lubriplate Low-Temp or equivalent. Inject the lubricant until it becomes

visible from the bleeder holes in the center of the swivel plugs.

• Periodically clean grit and dirt from around exterior moving parts.

• Periodically operate all functions of the monitor through its full travel.

• Replace the identification tag if it is worn or damaged.

ISO 9001 REGISTERED COMPANY

PHONE: 330.264.5678 or 800.228.1161 I FAX: 330.264.2944 or 800.531.7335 I akronbrass.com

WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship. Akron Brass will repair or replace product

which fails to satisfy this warranty. Repair or replacement shall be at the discretion of Akron Brass. Products must be promptly returned to Akron Brass for warranty service.

We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to follow

our instructions or recommendations; or anything else beyond our control. WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY STATEMENT,

AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. Further, we will not be responsible for any consequential, incidental or

indirect damages (including, but not limited to, any loss of profits) from any cause whatsoever. No person has authority to change this warranty.

REvISED: 8/11