dol sensors DOL 104 기술 사용 설명서 - 페이지 3

{카테고리_이름} dol sensors DOL 104에 대한 기술 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dol sensors DOL 104 4 페이지. 4-20 ma humidity sensor
dol sensors DOL 104에 대해서도 마찬가지입니다: 기술 사용 설명서 (4 페이지)

페이지 인쇄

LED/LIGHT PROTOCOL

LED

Green

Red

Flash

4 Maintenance

Clean the sensor with water and a brush without using:

• High-pressure cleaner

• Highly compressed air

• Solvents

• Corrosive/caustic agents

• Alcohol-based disinfectants

During cleaning and disinfection, the sensor should be removed and the sealing plug for the ca-

ble should be mounted. Alternatively, the sensor protective cap can be mounted. The sensor

must be placed with the tip pointing upwards during disinfection.

After the sensor has been exposed to water and condensation, it requires a period where the relative humidity

is lower than 80 %RH in order for it to measure correctly.

Do not bend the sensor as this would inflict permanent damage on the electronics of the sensor.

5 Technical data

Measurement range

Accuracy

Output signal

Time constant

Supply voltage

Current

Load

Recommended load

Max. output current

Output impedance

Cable

DOL 104 0-5 V

Status

Operation OK

Outside normal range

(below 10 % RH or exceeding 95 %

RH)

Connection error

Load < 500 Ω

Sensor defect

Over or under voltage alarm

Overload

% RH

V DC

Ω

kΩ

Ω

± 3% RH (40–85 %) ± 4% RH (10-95 %) at 0-40 °C

0.05 V / % RH

20 s at 0.5 m/s air speed

12 mA no load

35 mA max. load

> 500 Ω - < 10 MΩ

2 m 3 x 22 AWG / 0.34 mm

www.dol-sensors.com

Functional graph

0 - 100

11 – 30

≥ 100

< 1

Technical User Guide