Ashcroft ZT11-C3 설치 및 유지보수 지침 매뉴얼 - 페이지 4

{카테고리_이름} Ashcroft ZT11-C3에 대한 설치 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashcroft ZT11-C3 8 페이지. Non-sparking high purity transmitter

페이지 인쇄

Installation and Maintenance Instructions for

ZX11 Non-Sparking High Purity Transmitter

top of the instrument (Refer to "5. Outline

drawings"). Unit will not provide prescribed

performance if the air inlet is obstructed/

blocked.

• Do not apply excessive force or excessive

bending to the cable once the connector

is attached to the product and the mating

connector.

• Snoop test of the sensor part should be

avoided as this may cause an insulation

resistance defect.

• Prior to commencing operation, it is

recommended to purge the unit with

sufficient inert gas. This will remove any

atmospheric component, particles, and/or

foreign matter within the pipe

5.4 Storage Precautions

• To avoid failure or damage, do not store

product under the following conditions:

• Do not expose to water

• Susceptible to adverse effects due to air

pressure, temperature, humidity, ventilation,

sunlight, particles, salt or sulfur in the air

• Do not expose to inclination, vibration or

CAUTION:

shock (including during transportation)

• Do not expose to chemicals (chemicals'

storage area) or gas

• Do not expose to direct sunlight or high

temperature

• Deformation and discoloration of resin parts

may occur when product is stored in a

sealed bag under high temperature and high

humidity environments.

6. WIRING

6.1 Wiring schematic of mating connector

Wire connection and external connection should be carried

out as follows.

Insert the cable with M12 connector (optional) while aligning

to the connector groove on the instrument. Hand-tighten

until the nut does not move. [Tightening torque: 0.4 to 0.5N

CONNECTOR

TERMINAL ARRAY

All sales subject to standard terms and conditions of sale. ZX11_Transducer_im_RevA_(I&M011-10278)_06-05-20

•

2-WIRE SYSTEM

CABLE COLOR

Power Source +

Brown

—

White

Power Source -

Blue

—

Black

6.2 Load Resistance

Refer to the following chart for relationship between load

resistance and power supply voltage.

Power Supply & Load Resistance

1000

900

800

700

600

500

400

300

200

100

R Lmax

Maximum load resistance

Minimum load resistance

[Current output: 4 to 20mA DC (2-wire system)

ZX11

[Lead: Brown]

[Connector: 1]

[Connector: 3]

[Lead: Blue]

When connecting equipment that can generate surge from the

same power supply, it is recommended that a voltage-depen-

dent resistor (varistor) be connected to the pressure transmitter

for protection. In addition, take the following precautions when

wiring:

•

Do not pull or bend the cable with excessive

force.

•

When mounting, check the specification rat-

ing of the product and determine the power

supply rating to be used. Once the product

load resistance has been verified, use the

Operating Range

Power Supply (Vdc)

R Lmin

E (V)-10(V) ( )

R L

max

0.02(A)

R Lmin E (V)-26.4(V) , R Lmin ≥o( )

0.02(A)

Non-Hazardous Area

Power

Source [+]

15 to

24V dc

4-20mA dc

Power

Source [–]

Receiver

Connector