1010music Blackbox 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} 1010music Blackbox에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 1010music Blackbox 6 페이지.
1010music Blackbox에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)

play in a loop, select that section and touch Loop to activate loop mode, then press PLAY. Touch Loop again when you

are ready to fall through to the next section.

Once you have a few sequences recorded, you can create your own song section. A new preset starts with one song

section and you can add more up to a total of 16 sections per preset. Touch Edit, then ADD to insert a new section after

the currently selected section. When you are in Song mode, the PLAY button will play both the current song section and

any active sequences. The REC + PLAY button combination will record sequence on and off events into the currently

selected section. Please note that Song mode only records sequences. It does not record anything played on PADS or

KEYS screen. But you can use PADS and KEYS to play along with what you have recorded.

The SONG screen also allows you to change the BPM of the internal clock, and alter the length of each song section.

The current BPM is displayed in the top left below the bars and beats counter. Turn the top left knob to adjust the BPM.

Select a section and push INFO to view and change the number of beats in this section. Back on the main SONG page,

use the EDIT menu to manipulate song sections.

Effects

On the FX screen, you can configure two different effects and see which pads are sending

their output to that effect. To do this, we'll need to go back and send the output of one

or more pads to each of the effects. Push PADS and select a pad. Push INFO twice and

you will see an output select button next to the grid icon in the top left corner. Touch the

output selector and then touch FX1 or FX2 to send this pad to the corresponding effects

bus. Now push FX to go back to the FX screen. Touch one of the FX panels on either the

left or right side of the screen to select it. The pads that are assigned to this FX bus are

now highlighted pink. Push INFO to cycle through the parameters for this effect. The left

effect is a delay and the right effect is a reverb. The output of the effects will be routed to

Out1. Turn the knobs to adjust the parameters and hear the results in real-time as a sequence or song section is playing.

Blackbox will record the final state of the effects parameters in the preset.

Mixer

On the MIX screen you can independently adjust the volume and pan of each pad. The

number on the pad represents the dB level of the audio output. Turn one of the top two

knobs to adjust the level of the currently selected pad. The bar at the bottom of the grid

cell represents the pan position for the pad. Pan is only available if the pad is routed to a

stereo output. When the pan line is in the middle, the output is balanced equally between

left and right. Turn one of the bottom two knobs to adjust the pan.

The MIX screen also allows you to mute individual pads. Push the INFO button on the

MIX screen to enter MUTE mode. In this mode, active pads have a green background and

muted pads have a red background. Push INFO again to go back to controlling level and pan. Any muted pads will have

a red bar across the top of the pad.

3/18/19 6:19 PM

Figure 8 : FX S creen

Figure 9: M IX Screen

P. 4 of 6