CYP CH-1507TX 운영 매뉴얼 - 페이지 7

{카테고리_이름} CYP CH-1507TX에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP CH-1507TX 13 페이지. Hdmi to cat5e/6 with lan/ir/rs-232/poe

6. OPERATION CONTROLS AND FUNCTIONS

Front

HDMI IN

HDMI In: Connect to HDMI source equipment such as a DVD or Blu-

ray player.

LAN: Connect to an internet or network connection.

RS-232 In: Connect to a PC or Laptop with D-Sub 9 pin male cable

for the transmission of RS-232 commands.

Power LED: This blue LED will illuminate when the device is

connected to a power supply.

DC 48V: Plug the 48 V DC power supply into the unit and connect

the adaptor to an AC outlet.

IR 1 Blaster: Connect to the supplied IR Blaster cable for IR signal

transmission. Place the IR Blaster in direct line-of-sight of the

equipment to be controlled.

IR 2 Extender: Connect to the supplied IR Extender cables for IR

signal reception. Ensure that remote being used is within the direct

line-of-sight of the IR Extender.

Link LED: The yellow LED will illuminate when both the input source

and output display signals are connected through CAT cable.

When it blinks regularly it states the display is NOT sending signals

to receiver but the transmitter and receiver are linked and if it blink

irregularly it states an error has occurred.

CAT5e/6/7 Out: Connect to the Receiver unit with a Single

CAT5e/6/7 cable for transmission of all data signals.

Transmitter

RS-232 IN

HDMI to CAT5e/6/7 with LAN/IR/RS-232

Rear

POWER

IR1

BLASTER

DC 48V

IR2

EXTENDER