CYP CWHDI-TX1 운영 매뉴얼 - 페이지 10

{카테고리_이름} CYP CWHDI-TX1에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP CWHDI-TX1 12 페이지. Wireless hdmi transmitter and receiver box

페이지 인쇄

9. Troubleshooting

Situation

Power LED does not turn

on when power is on.

After powering on

Tx & Rx the Link's LED

is flashing repeatedly/

slowly without an image.

The Link's LED is

constantly on without

an image being

displayed or an

unexpected image is

displayed.

Input's LED does not

turn on.

Power LED is a different

color.

1. Check if the right adaptor is used (5V 2.6A adaptor).

2. Make sure all power connectors are correctly

plugged in.

3. Push the power button to turn on the device.

1. This is normal if the devices are connecting or in

search mode, the LED will slowly turn on when it is

doing signal linking, after that is done and when the

signal is transmitted and received the LED will be

consistent.

2. If the LED keeps on flashing for more than 3 minutes,

then repair the devices by pushing the ID keys for 2

seconds.

3. If the LED is still flashing slowly for more than 3

minutes, then make the input selection of the

Transmitter is correct.

1. Check if the source's timing is supported by the

device. The device supports up to 1080i so please

make sure the source is sending an acceptable

timing for the device and display and that the

display can also accept that timing.

2. Check if both source and the display are HDCP/CEC

compliant.

3. Check if TV mode is selected instead of HDMI mode.

4. Check if both source and display are connected.

1. When linking for the first time, if the output display

does not link up, the input LED will not switch on, so

please check if the HDMI output is connected.

1. A red Power LED means Broadcast mode and green

Power LED means Unicast mode. If Tx has a Green

LED but Rx has a red LED, press the Rx's ID for 10

seconds to change it to Unicast mode. But when

Broadcast mode is demanded press Tx's ID key for 10

seconds to switch to Broadcast mode.

Check Point