CYP PU-1109KIT 운영 매뉴얼 - 페이지 8
{카테고리_이름} CYP PU-1109KIT에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP PU-1109KIT 12 페이지. 5-play hdbaset™ extender kit (inc. poe & 3x lan, up to 100m)
CYP PU-1109KIT에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)
페이지 인쇄6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter
Front
HDMI
HDMI In
Bypass
LAN 1
1
2
1
HDMI Bypass: Connect to a HDMI TV/monitor for instant display of
the HDMI input source signal.
Note: When the HDMI bypass is connected, no signals will be transmitted
to the receiver side. Therefore, unplug this connection after confirming
that the correct image is displayed
2
HDMI In: Connect to the HDMI equipped source equipment such as
DVD or Blu-ray player.
3
LAN 1/2/3: The LAN connections can be used to connect and share up
to 6 ethernet connections (3 at the receiver end, 3 at the transmitter
end), including computers, routers and media servers.
4
Power LED: The red LED will illuminate when the 24 V DC Adaptor is
connected to the AC outlet.
5
DC 24V: This slot is where you plug the 24 V DC power supply into the
unit and connect the adaptor to an AC outlet.
6
IR 1 Blaster: Connect the IR blaster cables included in the package for
IR signal transmission. The related IR receiver port is IR1 Extender.
7
IR 2 Extender : Connect the IR receiver cables included in the package
for IR signal reception.The related IR transmitter port is IR2 Blaster.
8
RS-232 In: This slot is to connect with PC/laptop /Control Device with
D-Sub 9-pin male cable for sending RS-232 commands.
9
Link LED: This yellow LED will illuminate when the both CAT5e/6
input and output signal is connected.
10
CAT5e/6 Out: Connect the transmitter and receiver via a single
CAT5e/6 type cable for all data transmission.
8
LAN 2
LAN 3
3
Rear
DC 24V
Power
IR 1
IR 2
Blaster
Extender
RS232 In
4
5
6
7
Link
CAT5e/6 Out
8
9
10