Ashdown Geezer Buttler Pedal of Doom 사용자 설명서 - 페이지 3

{카테고리_이름} Ashdown Geezer Buttler Pedal of Doom에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashdown Geezer Buttler Pedal of Doom 18 페이지.

ASHDOWN ENGINEERING - PEDAL OF DOOM

TOP PANEL

VU METER 1

This is used to monitor the input level of your instrument. The Left Blue LED lights up in the VU

when E.Q. 1 is set and the Right Blue LED when E.Q. 2 is set.

VU METER 2

This is used to monitor the output level of the drive (Doom). The VU Blue LED lights up when the

Doom is engaged.

PEDAL OF DOOM

USER GUIDE

OUTPUT

This is used to set the overall output of the pedal, set to off and no sound will be heard.

BASS / LO MID / HI MID, E.Q. CHANNEL 1 (Left hand side)

The 3-band independent E.Q. can be used to dial in a tone for E.Q. Channel 1.

TREBLE

This controls the treble and is shared with E.Q. channel 1 & 2.

BASS / LO MID / HI MID, E.Q. CHANNEL 2 (Right hand side)

The 3-band independent E.Q .can be used to dial in a tone for EQ Channel 2.

DOOM

This dials in the amount of drive you want. From a small amount of edge to your tone to a world

ending distorted overdrive, this has you covered. CAUTION! Handle the DOOM level with care!

DOOM VOL

Sets the output level of your drive, when set to off and Doom is engaged (Blue LED light will be on

in the VU meter) no sound will be heard. Use this to match the volume of your amp or add a little

gain for a boost.

EQ 1/2 SWITCH

Use this foot switch to change between E.Q. setting 1 and E.Q. setting 2.

DOOM SWITCH

This foot switch engages the DOOM!!!

GROUND LIFT SWITCH

The ground lift switch eliminates unwanted hum and buzz if you are plugging into noisy

mains power.

USER GUIDE