CYP CH-1602RX 운영 매뉴얼 - 페이지 11
{카테고리_이름} CYP CH-1602RX에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP CH-1602RX 16 페이지. Hdmi over hdbaset transmitter and receiver with optical audio return (oar)
CYP CH-1602RX에 대해서도 마찬가지입니다: 운영 매뉴얼 (15 페이지)
페이지 인쇄
6.4 Receiver's Side Panels
OPT.
LAN
IN
1
2 3
LAN: Connect to an Ethernet supporting device or to your local
1
network as appropriate. The yellow LED will illuminate to indicate a
successful LAN connection between the Transmitter and Receiver
and will blink to indicate a data transmission. The green LED will
illuminate when the connected Ethernet speed is 100Mbit/s.
2
OPT. IN: Connect to audio source equipment such as a media
player or PC to transmit the audio signal to the Transmitter's OPT.
OUT port.
3
ARC IN/OPT. IN: Allows you to switch between sending audio to
the Transmitter from the HDMI output's ARC channel or from the
Receiver's OPT. IN port.
Note: When ARC is enabled the maximum supported HDMI cable
length may vary. It is suggested to use cables under 2 meters long
to ensure the best audio quality.
4
HDMI OUT: Connect to HDMI TVs, monitors or amplifiers for digital
video and audio output.
CAT5e/6/7 IN: Connect to the Transmitter unit with a single
5
Cat.5e/6/7 cable for transmission of all data signals. The yellow LED
will illuminate to indicate a successful data connection between
the Transmitter and Receiver. If the yellow LED blinks irregularly it
indicates a data link error. The green LED will illuminate to indicate
when PoH is active.
OPT.
ARC
IN
IN
HDMI OUT
4
CAT5e/6/7 IN
5
6