CYP PU-1107-KIT 운영 매뉴얼 - 페이지 9

{카테고리_이름} CYP PU-1107-KIT에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP PU-1107-KIT 12 페이지. Pure digital hdmi over single cat6 extender set, repeatable version
CYP PU-1107-KIT에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

페이지 인쇄

7.2 Rea r Pa nel

CH-1107TX

CAT6 OUT

EDID

10 Bit

TV/STD

12 Bit

8 Bit

EDID Control Switcher: Switch the EDID between STD and TV. Switch to

STD to use the built-in EDID or switch to TV to use the TV's EDID. The default

factory setting is TV, leave as is when the display is working properly.

Note: 1. When EDID is switched to STD the unit will use its built-in EDID which

supports:

Video → 1080p 8-bit, 10-bit or 12-bit (max)

Audio → PCM 2CH

2. The EDID selection will only be activated when the unit is re-plugged

and powered on.

CAT6 OUT/IN: Connect the CAT6 output of the transmitter with the CAT6

input of the receiver.

Note: A. This system was tested with CAT-6E/23AWG cables, so if using cables

of another type, results may vary.

B. Cable distance tested with PS3 120G & 40" Samsung LED 12 bit LCD

TV.

C.The gures provided in this manual are for reference only; actual

performance may depend on the source and display used along

with the type cable.

CH-107RX

CAT6 IN