Ashford DOUBLE TREADLE KIT 사용 설명서 - 페이지 4

{카테고리_이름} Ashford DOUBLE TREADLE KIT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashford DOUBLE TREADLE KIT 6 페이지. Traveller single or double drive
Ashford DOUBLE TREADLE KIT에 대해서도 마찬가지입니다: 지침 (2 페이지), 지침 (2 페이지), 지침 (2 페이지)

페이지 인쇄

If your wheel has ball bearing, reassemble as follows.

Insert the crank through the bearing in wheel sup-

port F. Slide the long crank spacer onto the crank as

shown.

Then place the wheel into position with the groove

for the hub pin away from the spinner and push the

crank through the hub. Turning the wheel as you

push will make this easier. Stop when the crank to

protrudes about 3mm (⅛") through the hub.

Then slide the short crank spacer onto the crank.

It is easier if you hold the spacer with a pair of fine

pliers or scissors. Then push the crank through the

hub and into the ball bearing until the hole for the

hub pin aligns with the slot in the hub.

Loosen the screw hold-

ing the rear leg to the

base. Remove the leg

and old treadle rail.

Rub candle wax onto

the steel pins projecting

from the new treadle rail.

Place the Double Treadle

Assembly into position

between the two legs.

Push the rear leg back

into the base and

retighten the screw. Then

sit the wheel back on its

feet.

Short spacer

Hub pin

Long Spacer

Crank