Ashford KIWI 3 SPINNING WHEEL 사용 설명서 - 페이지 14

{카테고리_이름} Ashford KIWI 3 SPINNING WHEEL에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashford KIWI 3 SPINNING WHEEL 14 페이지.

How to insert the polyurethane conrod

joints into the conrod. *This has been pre-

assembled in the factory.

How to fold your spinning wheel

1. Loosen the knobs

locking the feet.

2. Click the front conrod

off the crank.

3. Rotate the

wheel until the

front crank is

at the top.

4. Place the front

conrod in front of the

rear conrod while

folding the treadles

taking care to

position the crank

between the treadle

boards.

5. Then tighten

the knobs to lock

in the upright position.

Carry your Kiwi 3 either by the main upright,

wheel or maiden bar.

Ashford Handicrafts Limited

Factory and Showroom: 415 West Street

PO Box 474, Ashburton 7700 New Zealand

Telephone 64 3 308 9087

Email: [email protected] Internet: www.ashford.co.nz

Spinning

Before you begin spinning you need to tie a piece of

yarn called a leader, approx. 1.5m (5') long, on to the

bobbin. Thread it through the yarn guide, around the

flyer hook on the left-hand side of the flyer and out

through the orifice.

leader

* For further spinning and plying information refer to

"The Ashford Book of Hand Spinning" by Jo Reeve,

a 116 page book full of ideas and inspirations for

spinners or visit our website www.ashford.co.nz