CYP CDPS-UA1H10HS 운영 매뉴얼 - 페이지 8
{카테고리_이름} CYP CDPS-UA1H10HS에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP CDPS-UA1H10HS 12 페이지. 1 by 10 hdmi splitter with hdcp 2.2
CYP CDPS-UA1H10HS에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지)
페이지 인쇄
6.2 Rear Panel
HDMI IN
1
2
1
HDMI IN: Connect from source equipment such as Blu-ray/DVD/
1
PS3 players, Set-Top-Box or any HDMI equipped source device.
2
HDMI OUT 1~10: Connect to HDMI TV/display or HD Amplifier for
output video and/or audio.
3
SERVICE: This slot is reserved for firmware update use only.
4
SYS. RESET ON/OFF: Switch this switch to ON allow the device to
reset the output image with the source every 10 minutes.
It will force the connected TV/display to switch its HDMI port to
where the device is connected to ensure image display always.
Reset will be performed in sequence from 1~10 with 1 minute
a port. Default setting is OFF, leave as it is to disable the reset
function.
Note: TV/monitor must obtain CEC function in order to react
accordingly.
5
EDID STD/TV: Switch this switch to set HDMI EDID's setting.
Switch to TV mode allows the device to copy HDMI OUT 1's EDID.
For example, when input source support 4K2K contents and output
1 also connected with 4K2K display. The device will send 4K2K
contents to output 1~10 however, if output 2~10 are connected to
non-4K2K TV/monitor then port 2~10 may have no image display
therefore, to ensure all outputs obtain image display OUT 2~10's
EDID must obtain the equivalent EDID to OUT 1.
Switch to STD mode the EDID will support 1080p for video and PCM
2CH for audio.
6
DC 5V: Connect the adaptor included in the package and
connect to AC wall outlet for power supply.
4
HDMI OUT
3
4
5
6
2
7
8
9
10
SERVICE
DC 5V
SYS.RESET
EDID
ON OFF STD TV
3
4
5
6