CYP CHDBT-1H3CE 운영 매뉴얼 - 페이지 8

{카테고리_이름} CYP CHDBT-1H3CE에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP CHDBT-1H3CE 13 페이지. 1×4 hdmi over hdmi and cat5e/6/7 splitter with poe and lan serving
CYP CHDBT-1H3CE에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

페이지 인쇄
CYP CHDBT-1H3CE 운영 매뉴얼

6.2 Rear Panel

IR IN
IR OUT
1
2
1
IR IN: Connect with IR Extender to receive IR signal from Transmitter
side and blast out at Receiver side. Ensure that remote controller
being used is within he direct line-of-sight of the IR Extender.
2
IR OUT: Connect with IR Blaster to blast out the IR signal received
from the Receiver side. Place the IR Baster in direct line-of-sight of
the equipment to be controlled.
LAN: Connect to intra-net or internet service system for a total
3
sharing rate of 100Mbps within the link of Transmitter.
Warning: DO NOT connect this slot with any of the CAT5e/6/7 port,
doing so may trigger a power shot down and ruin the device.
CAT5e/6/7 OUT 1~3: Connect these ports to CAT5e/6/7 to HDMI
4
Receivers (with or without PoE function) with CAT5e/6/7 cable to
extend the signal up to 100m.
5
MODE & LINK 1~3: The Mode LED will illuminate when the device is
connected with power.
The link LED will illuminate when CAT5e/6/7 output(s) has been
connected to the Receiver(s) and the Receiver(s) has connected
with display that shows image on screen.
LAN
1
MODE
LINK
3
4
CAT5e / 6 / 7 OUT
2
3
MODE
LINK
MODE
5
LINK
4