DOLD MH 9063 원본 지침 번역 - 페이지 4
{카테고리_이름} DOLD MH 9063에 대한 원본 지침 번역을 온라인으로 검색하거나 PDF를 다운로드하세요. DOLD MH 9063 6 페이지. Varimeter current relay
페이지 인쇄Operating
Display (Run) -
mode
AC/DC
Ta
Rel2
Rel1
Esc 3s
I
AC [V]
DC [V]
RUN
Display (Run) - Modus
Display inverted when the actual value is in failure state.
No function
Reset fault memory:
For more the 3 sec, change to input mode
Esc
Input-mode
Measuring principle
AC or DC
Start up delay
Sp2
A/R
t 2
v
Hysteresis
>I
Response value for Rel2
<I
Sp1
A/R
t 1
v
Hysteresis
>I
Response value for Rel1
<I
Break
Esc (Break) 3s
(cancel changes)
OK-
(OK) 3s
(return with new settings)
M11491
After connecting the auxiliary supply A1/A2 the unit is in display (Run)
mode:
The actual measured value is displayed continuously (AC or DC)
The display is inverted when a measured value is exceeds the settings..
With button
the fault memory is reset.
Pressing button
for more than 3 sec the unit changes to input mode.
Esc
In input mode the measurement is disabled, the relays are in failure mode
and the indicator LED is orange.
With the buttons
the different setting values can be chosen.
Move cursor position
One character to the right
One character to the left
Esc
Back to the Display (Run)-Mode
Press button
3 s
or
Press button
3 s;
Esc
RUN
on the display confirm with
Input-Mode
Measurement interrupted, relays are in failure state,
indicator LED orange color
Chose Rel1, Rel2, T
a
Chose parameter
Change and set response values for Rel1 and Rel2.
Input places-switch:
Esc
For more than 3 sec, change to display mode
4
OK
New values stored
Break
Values unchanged
to change to display (Run) mode.
, AC/DC and RUN
Shift cursor to the left
Shift cursor to the right
11.01.21 en / 335A