Ashford Jack 조립 지침 매뉴얼 - 페이지 8

{카테고리_이름} Ashford Jack에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashford Jack 16 페이지.

6. Using

place 5

M8 x 25 Washers,

onto each lower steel rod followed by another lever assembly N. Repeat this procedure until all the lever assemblies are in

position, finishing with 5 washers. A drop of light oil on the rods will help make treadling easier.

Back Rail M

7. Locate the second rail M onto the steel rods and secure to blocks O using two

8. Identify the cloth beam supports F (left) and FX (right). FX has a counter-bored hole on the outside.

9. Attach but do not tighten FX to DX with a

180 Threaded Rod with Dome Nut and M6 X 16 Washer

the inside.

10. Slide the ratchet lever G onto the steel shaft on the cloth beam H and ensure the pawl engages the ratchet teeth.

11. Twist the cloth beam support FX up slightly and locate the cloth beam H into the nylon bush. Lower H so the holes in H and F

line up and then tap a

M6 Barrel

Nut

M6 x 16

Washer

M6 x 80

Hex Head

Bolt

onto the two lower steel rods followed by a lever assembly N. Place two washers

washers

Lever Assembly N

M6 x 80 Hex Head Bolt

. Repeat for the opposite side with F, D and E. Keeping the nylon bushes to

through the nylon bush and into H. Then tighten the bolts securing F and FX.

5/8 x 75 Steel Shaft

M6 Barrel

Nut

M6 X 16 Washer

M8 x 25 Washers

8 x 2 Screws at each end

and

and attach to EX with the

M6 Barrel Nut

M6 x 16

Washer

M6 x 180 Threaded Rod

and Dome Nut

M6 x