CYP PU-Q1H8C 운영 매뉴얼 - 페이지 9

{카테고리_이름} CYP PU-Q1H8C에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP PU-Q1H8C 16 페이지. Cyp pu-q1h8c distribution amplifier
CYP PU-Q1H8C에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지)

페이지 인쇄

7. Operation Controls and Functions

The following sections describe the hardware components of the unit with

installation and functionality.

7.1 Front Panel

① HDMI/DVI indicators: When LED illuminate this means the input source

is with HDMI content and when the input source is DVI the LED will not

illuminate.

② HDCP indicators: When the input source is with the HDCP protection the

HDCP LED will illuminate.

③ SYNC Indicator: The LED will illuminate when the device detected source's

signal.

④ Output LED1~8: The LED will illuminate when output display is connected

with power on.

⑤ Power LED: The LED will illuminate when power is on.

7.2 Rear Panel

①② ③ ④ ⑤ ⑥

① IR IN: This slot is to connect with the IR receiver cable included in the

package and use the existing source ' s remote controls to control source

equipments.

② IR OUT: This slot is to connect with the IR blaster cable included in the

package and place it in front of the sources for infrared signal sending.

③ EDID Control Switcher: Switch the EDID between STD & TV. Switch to STD

to use built-in EDID or switch to TV to use TV ' s EDID. Default factory setting

is on TV, leave as it is when picture is displayed properly.

Note:

1. When EDID switch to TV, the unit will detect the first HDMI output

sink ' s EDID and record in the unit. If the first detected output sink is DVI

it will pass to next source until the first HDMI source been detected. The

detection priority is HDMI v1.3 > HDMI v1.2 > DVI.

① ② ③

⑦

④

⑤

⑧