CYP QU-12S 운영 매뉴얼 - 페이지 8

{카테고리_이름} CYP QU-12S에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP QU-12S 16 페이지. 1 to 2 hdmi distribution amplifier with system reset
CYP QU-12S에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (12 페이지)

페이지 인쇄
CYP QU-12S 운영 매뉴얼

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Front Panel

1
POWER LED: This LED will illuminate to indicate the unit is on and
receiving power.
2
IN LED: This LED will illuminate to indicate that a live source has been
detected on the input port. When no source is detected the LED will
remain off.
3
OUT LEDs 1~2: These LEDs will illuminate to indicate when a valid
sink has been detected on the associated output port. When no sink is
detected the LED will remain off.
4
EDID SWITCH: This switch controls the EDID management behavior of
the unit. When set to "TV" mode the unit will read and store the EDID
from the sink connected to output 1 and pass it to the connected
source. When set to "STD" mode the unit will use a built in EDID
defined as 1080p@60Hz, 8-bit, LPCM 2.0.
5
SYS-RST SWITCH: Controls the CEC "active source" reset functionality
of the unit. When switched to the "ON" position the unit will send a
CEC active source reset command to all connected displays every 8~10
minutes. This command requests that any connected CEC compliant
TVs switch to the input the unit is connected on.
Note: The connected TV must have CEC support enabled. Not all HDMI
TVs support this CEC command.
6
SERVICE: This slot is reserved for firmware update use only.
8
POWER IN
OUT
1
2
1 2
3
EDID
SYS-RST
SERVICE
ON
OFF
STD
TV
4
5
6