Cypress CY4607 HX2VL 빠른 시작 매뉴얼
{카테고리_이름} Cypress CY4607 HX2VL에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cypress CY4607 HX2VL 2 페이지.
Cypress CY4607 HX2VL에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (9 페이지), 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
1
Insert the kit CD into the CD drive of your
PC. Review kit contents.
3
To connect to the PC, plug the USB A to B
cable into the hub's upstream connector.
Plug the other end of the cable into one of
the PC's host controller ports.
The hub is now ready for any low speed, full
speed, or high speed devices to be plugged
into the ports. The four ports on the hub are
labeled Port 1, Port 2, Port 3, and Port 4.
HX2VL DEVELOPMENT KIT
QUICK START GUIDE
2
Plug the wall mounted power supply into an
AC power receptacle providing power in the
range 100 V to 240 V, 50 Hz or 60 Hz.
Connect the power supply plug to the hub's
'DC Supply' jack.
4
Connect a USB device to any of the four
downstream ports. Use jumpers J7 to J10
(port status) in position 2 or 3 to enable the
port LEDs. The green LED indicates that the
port is enabled.
The amber LED indicates that the port has an
exception condition. The operating system
commands the HX2VL to turn off the port and
set the amber LED until the condition is
cleared.