Cypress CY8CPROTO-062S3-4343W 빠른 시작 매뉴얼
{카테고리_이름} Cypress CY8CPROTO-062S3-4343W에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cypress CY8CPROTO-062S3-4343W 3 페이지. Psoc 62s3 wi-fi bt prototyping kit
Cypress CY8CPROTO-062S3-4343W에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (3 페이지)
페이지 인쇄
CY8CPROTO-062S3-4343W PS
KitProg3 USB
connector (J8)
Before starting, ensure you have the following.
• PC with USB port
• UART terminal software such as Tera Term or Minicom
1) Visit the kit website to download and install the required software.
2) Ensure the jumper J3 is at position 2-3 to select 3.3V.
3) Connect the KitProg3 USB connector (J8) to your PC.
4) Wait for the drivers installation to complete.
5) Open the UART terminal software and connect to the KitProg3.
USB-UART COM port with the settings – Baud rate: 115200,
Data: 8 bit, Parity: None, Stop bit: 1 bit, Flow control: None.
© 2019-2020 Cypress Semiconductor Corporation. All rights
reserved. All trademarks or registered trademarks referenced
herein are the properties of their respective owners.
002-28125 Rev.*E
C
62S3 Wi-Fi BT PROTOTYPING KIT QUICK START GUIDE
®
O
All manuals and user guides at all-guides.com
For more information, please visit:
6) Press the RESET switch (SW1) on the device.
7) Follow the instructions displayed on the UART terminal to use the
pre-programmed code example.
Refer to the Kit Guide available at the kit website for details.
www.cypress.com/CY8CPROTO-062S3-4343W
Contains Model: Type1DX
FCC ID: VPYLB1DX
IC: 772C-LB1DX
001-P00840
Power selection jumper (J3)
Reset button (SW1)