Cypress CY3250-29XXX 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Cypress CY3250-29XXX에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cypress CY3250-29XXX 2 페이지.
페이지 인쇄
The CY3250-29XXX emulation pod is designed to work with the PSoC
(In-Circuit Emulator). The pod requires pod feet that match your Cypress part foot-
print. The ICE Cube (CY3215-DK kit), pod feet, and CY3250-FLEXCABLE can be
purchased separately from the Cypress Online Store at www.cypress.com.
Getting Started
1.
Solder one of the emulation pod feet to your target board in place of the
Cypress CY8C29xxx part.
2.
Connect the larger end of the CY3250-FLEXCABLE to the ICE Cube emulator.
Ensure that power is being supplied to the ICE Cube. Also, ensure that the ICE
Cube is connected to your host PC via a USB cable provided with the CY3215-
DK In-Circuit Emulator Debugging Kit.
3.
Connect the smaller end of the CY3250-FLEXCABLE to the pod as shown on
the front side of this card.
4.
Secure the flex cable to the pod using the included compression plate and red
thumbscrews.
5.
Connect the pod to the foot previously soldered to your target board, making
sure the pins align correctly using the pin 1 indicators on the pod and foot.
6.
Open the PSoC Designer application
CY3215-DK kit, and create a firmware project using the appropriate device.
7.
To begin debugging your firmware project, follow the instructions within the
PSoC Designer application
For more information about the CY8C29xxx device, visit us at www.cypress.com.
There you will find data sheets and application notes. For application support, visit us
at www.cypress.com/go/support.
A.
Update to the latest PSoC Designer™ including service pack releases at:
http://www.cypress.com/psocdesigner
© Cypress Semiconductor Corporation, 2010. All rights reserved. PSoC is a registered
trademark and PSoC Designer™ is a trademark of Cypress Semiconductor Corp. All
other trademarks or registered trademarks referenced herein are the property of their
respective owners. The information contained herein is subject to change without
notice.
.
Thumbscrews and Compression Plates
A
, which is included on CD as part of the
Doc. # 001-65200 Rev. **
®
ICE Cube
29XXX Pod
Mask