Cloud Z8II 설치 및 사용 설명서 - 페이지 11

{카테고리_이름} Cloud Z8II에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cloud Z8II 18 페이지. Venue mixer

Plug-in Bose

Each zone board has the facility to connect a plug-in Bose

are available, a Model 8 EQ module and a Model 25,32,102 EQ module. When fitting a

module to one of the zone boards, proceed as follows:

• Disconnect the power connector from the mixer.

• Remove the top panel.

• Locate the zone board to be fitted with the module and locate CON2.

• Remove the jumper from pins 5 & 6 on the 10-way header CON2.

• Fit the nylon support post to the hole marked FIX by pressing firmly.

• Align the 10-pole module connector over CON2 and push together.

• Make sure that the nylon support post aligns with the hole in the module.

• Push the module against the mounting post until they 'click' together.

• The 10-pole connector is not polarised; take care to position the module correctly

and always use the mounting post if only to verify the correct position of the

module.

Important note:

Refer to Section 19 before installing a Bose

Active Modules – general specification.

The Cloud AE-1, DM-1 & LM-1 are the same physical size as a double UK electrical socket

(13A type) and can be mounted in the recessed back box provided or be surfaced mounted

in a standard 35mm deep housing. The modules should be connected to the facility input of

the host mixer using a single multi-core screened cable. The module terminations are

conventional screw terminals and the facility input on the host mixer is a 9-pin sub-D type

connector. A suitable 9 pin sub-D connector is provided. G

TERMINATING THE MODULES

ERRORS CAN CAUSE POWER SUPPLY PROBLEMS RESULTING IN TEMPORARY FAILURE OF THE

;

MIXER

ALWAYS CHECK YOUR WIRING BEFORE TESTING THE SYSTEM

Please refer to section 18 for further details of the facility input connector.

30/05/03 V8

Equaliser modules.

Zone board fitted with Bose

;

POWER IS DERIVED FROM THE HOST MIXER AND CERTAIN WIRING

& Z8

equaliser module. Two modules

Equalisation Module

EQ Module

REAT CARE MUST BE TAKEN WHEN

: Installation and User Guide