1010music Toolbox 빠른 시작 매뉴얼

{카테고리_이름} 1010music Toolbox에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 1010music Toolbox 2 페이지.
1010music Toolbox에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

Before You Start

A microSD card must be inserted into toolbox

before you can get started. All presets are stored

on the microSD card. Preset changes are only

saved when you choose to save them.

Overview

Toolbox offers touchscreen control of sequencers and

function generators that provide CV and MIDI outputs

for use in controlling other modules. Toolbox by itself

does not generate any sound.

The Main screen shows a representation of each of

the different sequencer and function outputs. The

columns of the screen display are mapped to the

input and output jacks below the screen. You can

touch the individual elements on the screen in

columns 2 through 4 to access parameter screens for

each element. Each row of input and output jacks

corresponds to a row of controls on the screen.

From left to right, the columns display the following:

Column

Name

Description

CV Mod In

Displays the state of the external control voltage modulation inputs in rows

1 through 3. Row 4 displays the state of CV Mod In 4 that controls

playback.

Gate

Displays a small representation of the four gate sequences. Touch each

Sequencers

row to configure the corresponding sequencer.

Note

Displays a small representation of the note sequences. Touch each row to

Sequencers

configure the corresponding note sequence. The left row of output jacks

below this row outputs the gate signal, and the right row outputs the pitch.

Function

Displays a representation of the CV voltage currently output by the

Generators

corresponding function generator or sequencer, from -5V to +5V. Touch

an LFO or SEQ button to configure the parameters.

Start Playback of the Sequencers and Function Generators

To control playback of the sequencers and function generators:

Press the HOME button to display the Main screen.

Touch Play in the lower left corner of the screen to toggle playback on and off.

Note:

Connect the outputs of Toolbox to a module that generates sound, such as Synthbox, to hear playback. You can use

•

the MIDI Outputs or the individual Note Sequencer Gate and Pitch Outputs.

You can also use CV Mod In 4 to control playback. Each high signal received on CV Mod In 4 will toggle playback on and off.

Select and Save a Preset

A preset is a set of pre-configured sequences, function generators and modulators. You can use the 1010music presets or create your

own.

Select a preset from the Main screen by touching + and – at the top of the Touch Screen on either side of the name of the

preset (e.g. STABS in the Main screen screenshot above).

To save changes to a preset, touch the preset name, Edit, then Save.

Mute Mode

You can use Mute Mode to temporarily disable playback of toolbox elements:

Press HOME to return to the Main screen if needed.

Press HOME to toggle Mute Mode on and off. The colors of the screen change to green and red. Green elements are active

and red elements are muted.

Touch boxes on the screen to mute them. Touch them again to re-activate them.

10/24/17 1:37 PM

Toolbox Quick Start Guide

Ma in Screen