Cloud BT-IAEW 설치 매뉴얼 - 페이지 7
{카테고리_이름} Cloud BT-IAEW에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cloud BT-IAEW 16 페이지. Bt-i series bluetooth wireless audio module
페이지 인쇄Installation - connections
Connection to a Facility Port (BT-1F only)
The BT-1 has two PCBs "piggy-backed" onto the rear of the faceplate. The RJ45 output connector (SK1) is located on the upper
PCB:
RJ45 OUTPUT
CONNECTOR
INSERT PLUG THIS
WAY, LATCH UPWARDS
LOCATION OF REAR RJ45 CONNECTOR
(Sketch simplified; only primary components shown)
The output connector should be connected to the host unit's FACILITY PORT for the Zone in which it is installed* with
screened Cat 5 cable and shielded RJ45 plugs.
Connect to SK1
100 m max
Screened
HOST UNIT (Z8
illustrated)
MK4
Cat 5 cable
Connect to
BT-1
FACILITY PORT
(UK version illustrated)
The maximum total Cat 5 cable length should not exceed 100 m. If further modules are being "linked" together (see "Connecting
a BT-1F to an LM-2" on page 10), this figure applies to the overall cable run from the host unit to the farthest module in the
chain.
BT-1 Installation Guide v1.0
7