Cloud LM-2 Series 설치 매뉴얼 - 페이지 8

{카테고리_이름} Cloud LM-2 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cloud LM-2 Series 12 페이지. Connecting an lm-2 to a line input on a z4mk4/z8mk4
Cloud LM-2 Series에 대해서도 마찬가지입니다: 기술 노트 (4 페이지)

페이지 인쇄

NOTE: Users should be aware when using simultaneous microphone and/or music sources from multiple linked modules that

the operation of the LM-2's Priority function may become unpredictable, and if the function is enabled, one microphone may

disable another, for example. We recommend that the Priority function is not used under these circumstances.

Remote controls

When modules are linked, only one may act as the remote control for each of the host unit's background music functions:

source and level. The MUSIC SOURCE and MUSIC LEVEL controls

page 4) on all but one of the linked modules must be disabled. This is done by moving jumpers J1 and/or J3 on the upper

PCB as required.

The default setting for J1 and J3 is LOCAL; this enables both the faceplate background music source and level controls. Set both

jumpers to LINK to "pass" the remote control functions to the LM-2 connected at the LINK connected.

Note that the two functions – background music source selection and background music level – may be disabled individually, so

that one LM-2 in a Zone could control the music source and another the music volume.

Note that it is also possible to "daisy-chain" standard Cloud RL-1 and RSL-6 remote control plates to the LINK connector.

This would be useful if additional background music control points were required in the Zone, but not additional system inputs.

Please refer to the Technical Notes section at

LM-2 Installation Guide v1.0

LM-2 LOWER PCB

PHONOS

LM-2 UPPER PCB

LOCATION OF JUMPERS

Link indicates default jumper setting

FUNCTION

LOCAL

Local LM-2 selects

Source select

music source

Local

LM-2

Level

music volume

www.cloud.co.uk

XLR

DISABLE

LINK

GATE

LINK THESE TWO PADS

and

(see "Faceplate Controls and Connections" on

LINK

Linked

LM-2

selects

music source

sets

Linked LM-2 sets music

volume

for further information on this topic.