Cloud CVS-C52T 설치 매뉴얼 - 페이지 3

{카테고리_이름} Cloud CVS-C52T에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cloud CVS-C52T 3 페이지.

Step 1

Cut a hole at the mounting location in the ceiling

using the template supplied. You can check that the

diameter is correct for the model by referring to the

table above.

Double check that there are no cables or other

obstructions behind the mounting surface before

making the cut-out.

Step 3

Make sure the mounting clamps are fully bent

inwards, allowing the speaker fit through the cut-out.

Insert the speaker to the opening.

Step 5

(only applies to models with removable grilles)

To attach the grill to the speaker, insert the lips into

the provided openings on the speaker baffle and

rotate it a partial turn (15°) to lock it into place.

Step 2

Strip the ends of the wires coming from the amplifier

and insert in the spring-loaded terminal block

connector on the loudspeaker. No screwdriver is

required.

The correct power tapping is chosen by connecting

to the appropriate terminals of the connector. A

description of the power tap selection is shown on the

magnet sticker on the rear side of the loudspeaker.

When using 100/70/25 V speakers in low impedance

mode (8Ω), disconnect the ground wires by

interrupting the cable lugs.

Step 4

Fix the speaker in the provided opening by tightening

the screws of the mounting clamps using a

screwdriver. A quarter turn will cause the mounting

clamps to flip-out, locking the speaker in place.

Tighten the screws further until the speaker unit is

fully secure.

Step 6

The speaker is now correctly installed and ready for

use.

CVS Series Installation Guide V1.0