Ashly ne1600 운영 매뉴얼 - 페이지 6

{카테고리_이름} Ashly ne1600에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly ne1600 12 페이지. Network enabled two channel power amplifiers
Ashly ne1600에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지), 운영 매뉴얼 (16 페이지)

페이지 인쇄

Operating Manual - NE Two Channel Power Amplifiers

Amplifier Rear Panel

1. Optional CobraNet CNM-2 Card or AES/EBU Input Slot – Installation of an optional CobraNet CNM-2

card option allows this amplifier to be part of a CobraNet audio network. Installation of the AES/EBU

input option in this slot allows for digital audio input in the AES/EBU format.

2. Ethernet Port - This offers 10/100 Ethernet control and monitoring of amplifier functions using Protea

software.

3. Analog Inputs - XLR inputs are pin 2 (+), pin 3 (-), and pin 1 (G). Euroblock inputs are wired in parallel to the

XLRs. If an unbalanced (single ended) input is used, be sure to ground the unused input pin.

4. Normal/Bridge Switch - This switches the amplifier to Bridge Mode.

5. Normal/80 Hz HPF - This switch enables a second order High-Pass filter set to 80Hz on both inputs.

6. Input Sensitivity Switch - This switch selects the input sensitivity for both channels to 26dB, 32dB, or 1.4V.

7. Speakon Speaker Connectors - Used to connect the speakers.

8. Euroblock Speaker Connectors - This connector is wired in parallel to the Speakon speaker outputs.

9. Analog Aux Outputs - Used to drive additional amplifiers.

10. Remote Standby - Connect these two contact closure pins to remotely place the amp in standby.

11. Remote Level Control - These pins can be wired to remote potentiometers such as the Ashly WR-1 for level

control of individual channels.

12. AC Inlet - Used for the detachable AC cord.

WARNING: Do not remove or lift the mains connector ground.

Installation

Before connecting to mains power, make sure that the switches and wiring are all set to the configuration needed

for your particular application. Failure to do so could result in damage to the unit or other components in your system.

CAUTION: When mounting or connecting the amplifier, always disconnect it from the mains. Use four screws and

washers when mounting the amplifier to the front rack rails. Rear support is also recommended, especially for mobile or

touring use. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.