Ashly Power Amplifiers FET-200 사용 설명서 - 페이지 6
{카테고리_이름} Ashly Power Amplifiers FET-200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly Power Amplifiers FET-200 14 페이지. Mos-fet power amplifiers
Ashly Power Amplifiers FET-200에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)
페이지 인쇄
INPUT AND OUTPUT CONNECTIONS
STEREO OPERATION
Connections for stereo operation are shown in figure 4 below.
R
L
V- OUTPUTS ^
MIXING
CONSOLE
+
+
Figure 4
Stereo Operation
INPUTS
The
input
of Asnly amplifiers is a balanced bridging
type,
with
an
input
impedance
of lOk ohms.
Use of the balanced input provides superior hum
and
noise rejection while eliminating ground loops.
The input may also be used in
a single-ended, unbalanced mode by simply using unbalanced input connectors.
Each
channel provides a choice of either 1/4" jacks or XLR input
connectors.
All four connectors are in parallel.
Since only one of the four connectors is
used
as
an
input at any one time,
the others may be used to
jumper
other
amplifiers to the same source.
Signal connections are as follows:
The
(+) or in-phase connection is on the tip of the 1/4" stereo phone
jacks,
and is on pin 3 of the XLR connectors.
The (-) or out-of-phase connection is
on the ring of the phone jacks and on pin 2 of the XLR's.
Chassis ground and
shield is on the sleeve of the 1/4" jacks and pin 1 of the XLR's.
5