Ashly Protea NE4250.70 운영 매뉴얼 - 페이지 9

{카테고리_이름} Ashly Protea NE4250.70에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly Protea NE4250.70 16 페이지. Network enabled multi-channel power amplifiers
Ashly Protea NE4250.70에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 사양 시트 (2 페이지), 사양 (2 페이지), 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (20 페이지), 운영 매뉴얼 (20 페이지)

페이지 인쇄

Operating Manual - NE Multi Channel Power Amplifiers

The WR-5 is a microprocessor based remote

control unit which can be used with the NE multi-

channel amplifiers. The WR-5 is designed to fit into

a standard electrical wall box. Up to four WR-5

remotes can be phantom powered from one ampli-

fier, and adding more remotes is possible using an

external power supply. Each of six buttons on the

WR-5 can be programmed to engage one of the fol-

lowing functions:

1) Preset recall

2) Preset scroll

3) Channel volume

4) Channel mute

5) Zone input source selection (requires DSP)

Programming of each button is done from Pro-

tea Software when the WR-5 is wired to its host NE am-

plifier, and the amplifier is connected to a PC via ethernet.

Up to four WR-5 units can be daisy-chained from the same

amplifier. See your Ashly dealer or visit the Ashly web

site at www.ashly.com for more WR-5 details.

RD-8C or RW-8C Remote Control

A second microprocessor based controller, the Ashly

RD-8C, is an eight channel wall mount level controller

that uses slide faders for individual channel and master

level control and mute. NOTE: When an RD-8C is used,

no other microprocessor based remotes can be used.

WR-1 Remote Level Control

Individual amplifier channels can have remote level

control using a potentiometer assembly such as the Ashly

WR-1 and four conductor wire. The WR-1 is a dual po-

tentiometer remote volume control designed to fit in a stan-

dard wall electrical box. Each volume control is connected

to a terminal block on the WR-1 circuit board, which in

turn must be wired to the amplifier back panel euroblock

connector labeled "Remote Level Control" as shown. Do

not connect the WR-1 remote level control ground to any

other external grounds.

Ashly WR-5 Remote Control

Ashly RD-8C Remote Control

Ashly WR-1 Remote Attenuator

CV-2

CV-1