Acquisitions Bloomsbury SE 설치 및 사용자 지침 - 페이지 6

{카테고리_이름} Acquisitions Bloomsbury SE에 대한 설치 및 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Acquisitions Bloomsbury SE 6 페이지. Smoke exempt woodburning stove

페이지 인쇄

of the stove. Loading the stove little and often will help keep the stove temperature steady.

When loading wood, make sure that the end grain of the wood in the stove is pointing away

from the glass, otherwise the moisture and gases coming from the end grain of the wood

will dirty the glass.

TYPES OF WOOD FOR FUEL

For best results use well seasoned hardwood such as Oak, Ash or Beech. Allow wood to

dry out under cover in well-ventilated conditions for at least twelve months. As a rough

guide wood is ready for burning when radial cracks appear in the end of logs. Properly dry

wood means it should have a moisture content of between15%-20% which can only be

accurately measured using a moisture meter. Burning wood that is not seasoned will result

in tar being deposited in the stove, on the glass and in the flueways. This build up of tar is a

hazard and if it ignites may cause a chimney fire. Resinous softwood burns well and gives

a high output for short periods but is not as efficient and does not last as long as hardwood.

RE-FUELLING

Adding a 'little fuel often' is the best re-fuelling method to keep smoke to a minimum. Our

tests have shown that burning logs not longer than 20cm and with a width or diameter of

no more than 12cm will produce the optimum smoke free performance.

The above text should be used as a guide only. The ideal operation of your

stove depends on a number of factors, which vary with each installation, and

so gaining experience operating your stove is the only way to learn its best

operation.

Your stove should not be used as an incinerator and only recommended

fuels shall be used.

The stove as with any other metal products will expand and contract. A

ticking noise may occur. This is normal for this type of appliance.

MAINTENANCE

CLEANING THE STOVE

The stove should only be cleaned when it is cold. The exterior can be dusted with a firm

brush. Do not use a cloth, as this will drag on the paint finish leaving lint on the surface.

From time to time it may be necessary to renovate the exterior by repainting. High temperature

stove paints in aerosol form are available from your stove dealer. Do not use this form of

paint until the stove is cold and always read the instructions on the container before starting

to paint. The door glass is made of a special heat resisting ceramic and may be cleaned

when cold with proprietary glass cleaning liquids and a dry cloth.

SHUTTING DOWN THE STOVE (LONG TERM)

The following procedure should be followed if the stove is not to be used for a long period,

summertime for instance. Remove all the ashes from the grate and ash pan and use a

vacuum cleaner nozzle to clean ash from the base of the stove. Remove the baffle plate

and brush the flue ways. Close the door and open the air inlets fully. This action will allow

air circulation through the flue ways and help avoid corrosion and condensation.

SERVICING

Regular maintenance should be carried out by a competent engineer.

TECHNICAL INFORMATION

Normal heat output - wood

Weight of stove

Minimum chimney draught

Mean flue gas temperature - wood

Flue gas mass flow - wood

This appliance is not suitable for installation in a shared flue system.

5.0kW

83.6kg

10 Pa

244°C

3.1 g/s