Ashly Protea NE8250.10 운영 매뉴얼 - 페이지 13

{카테고리_이름} Ashly Protea NE8250.10에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly Protea NE8250.10 16 페이지. Network enabled multi-channel power amplifiers
Ashly Protea NE8250.10에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지), 사양 (2 페이지), 사양 시트 (2 페이지), 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (20 페이지), 운영 매뉴얼 (20 페이지)

페이지 인쇄

Operating Manual - NE Multi Channel Power Amplifier

side, with a cross linking matrix mixer in between. Key features of the DSP window include:

Input Channel Number - Right click on this to bring up Clear, Copy/Paste, Link, and Sub Preset for that input channel.

Input Channel Name - The user can name each input channel.

Input Mute Button - Mutes the input.

Pluggable DSP Tools - Six blocks are available on both inputs and outputs for custom configuration of pluggable DSP

processing blocks. Total DSP usage for the four input and output channels is indicated as a percentage at the bottom of each

input section in the DSP tab. Increasing the number and complexity of applied DSP tools increases the DSP usage. Note: The

total DSP usage per group of four channels is limited, and cannot exceed 100%. Available DSP tools include:

1) Dynamics controls - Brick Wall Limiter, Compressor, Autoleveler, Ducker, Noise Gate

2) Gain functions - Gain, Gain with VCA, RD-8C Remote Control Gain, neWR-5 Remote Control Gain

3) Equalization - Graphic Equalizer, 10/6/4/2 Band Parametric Equalizers

4) Crossover functions - Four Way, Three Way, and Two Way Crossovers are available on outputs only.

HPF and LPF filters are available on both inputs and outputs.

5) Delay - Speaker Delay at 48kHz sampling rate is 256mS, and Delay is 682mS. At 96kHz, 128mS and 341ms.

6) Metering - -60dBu to +20dBu display

7) Signal Generator - Pink noise, White Noise, Sine Wave

Extensive online help information is available for all DSP blocks within the software. From within any DSP tool, simply

press <F1> on the keyboard for online help for that tool. Also look in the Protea

Contents/Protea NE Products/PE Multichannel Amplifiers/DSP Control for details of all DSP functions.

Input/Output Matrix Router - Any input can be routed to any or all outputs. Click and drag from the input to output to

assign routing. For faster routing of a single input or output to multiple channels, highlight its node and then press Ctrl+Click

over the desired nodes to connect to. To delete a route or clear the matrix, right click on the routing line or node. Also, right

click anywhere in the matrix area to bring up a menu of common routing choices.

Output Mute Button - Mutes the output.

Output Channel Name - The user can name each output channel.

Output Channel Number - Right click on this to bring up Clear, Copy, Link, and Sub Preset functions for that output.

Software Help Menu/Contents and Index/