Ashly TM-360 운영 매뉴얼 - 페이지 5

{카테고리_이름} Ashly TM-360에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly TM-360 16 페이지. Public address amplifier
Ashly TM-360에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 빠른 매뉴얼 (1 페이지), 빠른 매뉴얼 (1 페이지), 빠른 매뉴얼 (1 페이지), 빠른 매뉴얼 (1 페이지)

페이지 인쇄

Operating Manual - TM-360 Public Address Amplifier

Rear Panel Features

1) AC Mains

This is the AC cord for connecting to 120VAC mains, 60Hz, 24W.

2) Main Speaker Outputs

This 5.08mm Euroblock connector is used for the main speaker output wiring. For low impedance

speaker loads, minimum 4 Ohm, connect between the COM and 16V/4 Ohm pins. For 25V or 70V

speaker loads (70V and 100V output taps on 230VAC models), the LINK wire must first be installed

between the 16V/4 Ohm pin and OPT IN pin, then connect the speaker load between COM and 25V

or 70V pins.

3) Zone 2 and Preamp Outputs

In addition to the main 60 Watt amplifier output, there is a separate ZONE 2 output which is a

switch selectable mix of channels 1, 2, or 3. This output is not effected by the priority ducking/mute

action or by the bass/treble EQ controls.

The ZONE-2 output provides two signals; 1) a low impedance output that is capable of continuously

driving 1 Watt into an 8 Ohm loudspeaker, and 2) a 600 Ohms transformer balanced output. Zone 2

output is controlled by the rear panel Zone 2 level control, as well as the three channel assign DIP

switches.

The PRE OUT connection is used for driving additional external devices with the same signal that

drives the main TM-360 power amplifier. The PRE OUT 600 Ohm output signal is taken before the

master volume control.

4) Zone 2 Level Control

This controls the level of the Zone 2 output signal.