Ashly MX-206 기술 노트 및 사양

{카테고리_이름} Ashly MX-206에 대한 기술 노트 및 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly MX-206 2 페이지. Stereo microphone mixer
Ashly MX-206에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지), 운영 매뉴얼 (8 페이지), 운영 매뉴얼 (9 페이지), 운영 매뉴얼 (12 페이지)

페이지 인쇄

MX-206 Stereo Microphone Mixer

ARCHITECTS SPECIFICATIONS

MX-206

The unit shall be a six input stereo micro-

phone mixer with TRS stereo outputs as

well as a transformer-isolated +24 dBm ,

600 ohm balanced XLR mono output. There

shall be +48 volts of phantom power avail-

able for condenser microphones, with gradual

power-up and down of this phantom power to

eliminate any transient spikes. Total voltage

gain measured from each microphone input

to the Master Output shall be a minimum of

84dB. Each of the six microphone channels

shall have 40dB of adjustable gain via a front

panel 3 position slide switch. Each input shall

also have a 20dB pad switch on the rear of

the unit, making a total of 60dB of possible

gain/attenuation. Each channel shall have a

continuously variable pan control. There shall

be a peak Clip LED indicator on each input

channel which shall illuminate when the input

is 3dB below true clipping, and another Clip

indicator on the output of the mixer which

shall illuminate when the output is within 3dB

of actual clipping. Two 6-segment LED meters

must be provided to monitor the mixer output,

calibrated for 0 VU to equal +4 dbu. There

shall be a separate stereo aux input with front

panel level control, having rear panel con-

nection via RCA phono jacks. There shall also

be a separate stereo aux output available on

the rear panel with access via RCA phono

jacks. Distortion shall be less than 0.02 %

Total Harmonic Distortion at +20dBu (20Hz to

20kHz) and less than 0.05% Intermodulation

Distortion (SMPTE) at +20 dBu (input switch

at -40dB). Hum and Noise shall be less than

-100dBu residual output noise when all levels

are set at minimum. Frequency Response shall

be +0/-.5dB, 20 Hz-20 kHz. Crosstalk of the

unit shall be less than -60dB when measuring

adjacent inputs or input to output at 20kHz.

Dimensions of the model shall be 19" wide

x 1.75" high x 6.6" deep. The mixer shall be

made in America, with a 10 pound shipping

weight.

The mixer shall be the model MX-206,

manufactured by Ashly Audio, Inc. of Webster,

New York. No other unit shall be acceptable

unless data submitted from an independent

test laboratory verifies that the above specifi-

cations are met.

TECHNICAL NOTES & SPECIFICATIONS

Features

• High Gain (84dB Channel Input to

Program Output) Ensures Full Output

with Low Level or Distant Mics

• Transformer Isolated +24dBm 600

ohm Balanced XLR Mono Output

• Pan Control on Each Channel

• +48V Phantom Power for Condenser

Mics

• Auxillary Tape/CD Inputs and Outputs

• Stereo Headphone Jack with Level

Control

• Safety/Compliance: cTUVus/CE, RoHS