Ashly MX-406 운영 매뉴얼 - 페이지 5

{카테고리_이름} Ashly MX-406에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly MX-406 12 페이지. Stereo microphone/line mixer
Ashly MX-406에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지), 기술 노트 및 사양 (2 페이지), 운영 매뉴얼 (12 페이지), 운영 매뉴얼 (16 페이지)

페이지 인쇄

expanding the channel capacity of the MX-406, the stereo

line input can be used as stacking inputs for supplement-

ing the MX-406 with another mixer, such as an Ashly LX-

308 stereo line level mixer.

4.7 Aux Master Output

This control adjust the level of the aux master

¼" jack output, which gets it's signal from the six aux

level controls on the input channels. It is used for an

effects unit send, or can drive a power amplifier for moni-

tors or an extra loudspeaker zone.

4.8 Main Outputs

These two controls determine the signal level to

the ¼" jack left and right outputs. They are used to drive

power amplifiers for the main loudspeakers, or to con-

nect to a stereo recording device.

4.9 Mono/Phones Output

Thinner concentric knob adjusts the level of the

summed mono output. It is completely independent of the

main left and right master controls. In other words, changes

to either left or right output level will not affect the mono

output level.

The outer concentric knob adjusts the level of the

stereo signal to the headphone jack. Headphones should

have an impedance of 600 ohms or greater, or signal dis-

tortion may result.

Operating Manual - MX-406 Stereo Microphone/Line Mixer

used to indicate stereo output level in VU. 0 VU is equiva-

lent to +4 dBu (1.228Vrms).

0 VU and two red LED's indicate clipping. The clip LED's

turn on 3dB below actual clipping, detecting excessive

signal level on any critical audio path within the master

section. If all outputs are turned down and there is still

clipping, then one or more inputs must be turned down.

When the switch is pressed in, the LED is lit and +48VDC

is applied to all six mic inputs for use with condenser

microphones. If there is a mix of both condenser and

dynamic microphones, the phantom power will not affect

the operation of the most dynamic mics.

4.10 Output Meters

A pair of peak reading 10 segment LED meters are

Green LED's are used below 0 VU, yellow above

4.11 Phantom Power LED

The phantom power switch is on the back panel.