Cypress UNIVERSAL CAPSENSE CY3280-BMM 빠른 시작 매뉴얼

{카테고리_이름} Cypress UNIVERSAL CAPSENSE CY3280-BMM에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cypress UNIVERSAL CAPSENSE CY3280-BMM 2 페이지. Matrix button module kit

페이지 인쇄

CY3280-BMM UNIVERSAL CAPSENSE

1. Insert the kit CD in the CD drive.

2. Install kit content, PSoC Designer, PSoC

Programmer, and Bridge Control Panel.

Note The hardware prerequisites for this kit are

the CY3280-20x34 Universal CapSense

Controller (UCC) board and MiniProg1

1. Connect MiniProg1 to the CY3280-

20x34 UCC board's ISSP connector (J1).

Connect it to your PC using a USB cable.

2. Open PSoC Programmer and click

File > File Load. Browse and load the

CY3280_20x34_PD_Project1.hex file.*

3. Click Connect; connect MiniProg1 to PC.

4. Click the Program button to program the

device.

5. Click the Toggle button to power the

board.

* Note These files are located at:

<Install directory> \Cypress\CY3280

BMM\<version>\Firmware

MATRIX BUTTON MODULE KIT

QUICK START GUIDE

1. Connect the CY3280-BMM board to the

CY3280-20x34 UCC board's P2 connector.

2. In the CY3280-20x34 board, place the

jumper on header J1 to short pins 2 and 3.

3. In the CY3280-BMM board, place the

jumper on header J2 to short pins 2 and 3.

1. Touch one button at a time. The

corresponding row and column LED

lights up with each touch, indicating

the button you touched.

2. If you touch more than one button,

all the LEDs are turned off because

multi touch is not supported.