Ashly GQX-1502 운영 매뉴얼 - 페이지 6

{카테고리_이름} Ashly GQX-1502에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly GQX-1502 12 페이지. Ashly gqx-1502 graphic equalizer: operating manual
Ashly GQX-1502에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 기술 노트 및 사양 (2 페이지)

페이지 인쇄

Page - 6

Safety Instructions – 3

Introduction - 4

GQX Equalizers – 5

The GQX-3102 is 3RU, and weighs 12 pounds, while the GQX-1502 is 2RU, and weighs 9

pounds. This manual shows images of both models.

Connectors & Cables – 5

Physical Description - 6

Front Panel

Rear Panel

Installation – 7

Typical Applications - 8

Troubleshooting - 9

Dimensions - 9

Specifications - 10

Warranty - 11

GQX-3102 Front Panel

Power – Switches the unit power on or off.

Equalization - The individual equalization

faders adjust the gain or loss at each filter

frequency. There are 31 of these faders per

channel on the 3102, and 15 faders per

channel on the 1502. By adjusting a

combination of faders, an overall frequency

response can be developed and the physical

position of the faders will give an approximate

visual indication of this response.

Gain - The gain control adjusts the overall gain

of the equalizer when the EQ switch is "in". It is

generally used to compensate for level

changes due to the equalization process, but

can also adjust overall system level and gain

structure. Overall gain with this control is from

+6dB to - .

Level Meters - On the GQX-3102, a 10-

segment, two color LED level meter indicates

the output level of the equalizer. A Clip

indicator LED on all models illuminates when

any point in the equalizer signal path reaches a

level within 3dB of clipping.

Operator Manual – GQX Series Equalizers

Range Switch - This switch selects the

operating range of the individual equalization

faders between 15dB and 6dB on the 3102.

The 15dB settings should be used when this

much equalization is needed. The 6dB setting

allows finer resolution on the fader settings.

EQ Bypass Switch - This switches the Graphic

Equalization and gain adjustments, allowing the

effect of any equalization to be compared to a

"flat" response. This switch does not defeat the

High-pass filter.

High-Pass Filter - The high-pass filter can be

used to supplement the frequency response

achieved by the bandpass filters. Its function is

to "roll off" the response below a given

frequency eliminating subsonic interference like

wind noise or floor rumble. This frequency is

adjustable between 14Hz and 280Hz on the

3102, and is fixed at 40Hz on the 1502.