Ashly GQX-3102 운영 매뉴얼 - 페이지 7

{카테고리_이름} Ashly GQX-3102에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly GQX-3102 12 페이지. Graphic equalizer
Ashly GQX-3102에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 기술 노트 및 사양 (2 페이지), 운영 매뉴얼 (13 페이지)

페이지 인쇄

Operator Manual – GQX Series Equalizers

GQX-1502 Rear Panel

Inputs - For unbalanced inputs, the signal

should be on the + connection and the -

connection tied to ground. A mono 1/4" plug

used as an unbalanced connection will

automatically be grounded. When using a

stereo plug, XLR connector, or Euroblock for an

unbalanced signal, the (-) input connection

MUST be tied to ground.

Use four screws and washers when rack mounting the Equalizer. For mobile use, the unit

should be further secured as appropriate.

General Requirements

GQX Equalizers have specific physical, electrical and signal requirements for proper

operation. These requirements will vary depending on your specific application, setup, and

the settings on the Equalizer. When setting up and testing your system, please take special

care to double check all connections and settings. Please refer to the specifications section

of this manual for specific input, output and other figures.

AC Power

Your GQX equalizer should be connected to a standard 3-wire grounded electrical outlet

supplying 100-240 Volts, 50-60 Hz. To reduce the risk of ground loop hum, connect all

audio equipment to the same electrical power source. Removal of the ground pin is both

unlawful and dangerous, as a potential shock hazard could result.

This unit will perform normally within the AC voltage range specified above. Voltages

less than this, as found in "brown-out" conditions, may reduce performance. In the event of

a blown fuse, replace only with same type fuse. No user serviceable parts are inside the

chassis. Overall power consumption is less than 25 watts.

NOTE: The power switch does NOT isolate the appliance from mains. Make sure the mains

power socket or an alternative disconnect device is near by and easily accessible. When the

product is connected to mains, the line-filter and the input of the fuse are energized.

Ashly Servo-Balanced Output - This output

circuit is an active output which maintains a

constant output level between the (+) and (-)

output terminals, regardless of either terminal

being connected to ground. This servo-

balanced output provides an unchanged signal

without regard to ground.

Page - 7

Safety Instructions – 3

Introduction - 4

GQX Equalizers – 5

Connectors & Cables – 5

Physical Description - 6

Front Panel

Rear Panel

Installation – 7

General Requirements

AC Power

Typical Applications - 8

Troubleshooting - 9

Dimensions - 9

Specifications - 10

Warranty - 11