Cypress CLUX-22HC 운영 매뉴얼 - 페이지 9

{카테고리_이름} Cypress CLUX-22HC에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cypress CLUX-22HC 16 페이지. Hdmi/cat6 to hdmi/cat6 splitter switcher

7. Operation Controls and Functions

The following sections describe the hardware components of the unit.

HDMI/CAT6 input selection: Switch to select input sources from either

①

HDMI or CAT6.

EDID Control Switcher: The default factory setting is TV, do not switch if the

②

display is compatible. Switch to STD to use built-in EDID.

[Note]:

1. When EDID is switched to TV, the unit will detect and record the ﬁrst HDMI ' s

output EDID in the unit. If the ﬁrst detected HDMI output is DVI it will

continue to pass on to the next output until the ﬁrst HDMI output is found.

The detection priority is HDMI v1.3 > HDMI v1.2 > DVI.

2. When EDID is switched to STD the unit will use its own EDID which supports:

Video → 1080p 8-bit (max)

Audio → PCM 2CH

3. When EDID is switched to STD with input selection on HDMI or CAT6 IN the

display TV or monitor, they will automatically switch to HDMI input 1. When

EDID is switched to TV regardless of the input selection the display TV or

monitor will switch to HDMI input mode 1. Therefore it is not suggested to

switch the EDID to STD.

4. The EDID selection will activate only when the unit is plugged in and power

is on.

CEC output: Only when switched to HDMI, the HDMI ' s output port CEC will

③

bypass the CEC and proceed directly to the HDMI and CAT6 input ports.

When switched to HDMI and CAT6, the HDMI and CAT6 output ports CEC

will bypass the CEC and go proceed directly to the HDMI.

HDMI Input: Connect input port to the HDMI or DVI output port of your

④